The Cam Grooving Machining Application of GSK988TD System on the Combination Machine Tool of Four-Axis Linkage Turning and Milling
Customer’s Requirement:
- The chamfering of machining contour is even and the milling at the bottom is smooth.
-311-官網(wǎng)內(nèi)頁圖.jpg)
Material:
- Component contour: diameter contour φ36, length: 73
Material type: No.45# steelProgram, tool: Procedure 1 (Rough-starting): O1660（Rough-starting, raw-material φ36- procedure 1/ tool name: φ8R4 ball-cutter\ milling of each layer – 1mm for each layer）; Procedure 2 (Contour rough-starting): O1661（Contour rough-starting – procedure 2）/tool name: φ4 flat-cutter/milling of each layer – 0.2mm for each layer); Procedure 3 (Contour and fine-milling at its bottom: O1662（Contour and fine-milling – procedure 3/ tool name: φ4 flat-cutter）; Procedure 4 (Contour chamfering): O1663（contour chamfering – procedure 4/ tool name: φ4R2 ball-cutter）.
Notice:
- It is necessary to keep away from the interference between clamping workpiece and dynamic head when the chuck clamps the raw-material.
- Machining program (Note: The start, end, speed and feed of the program should be determined by the system and machine tool).
Machining samples and videos
-311-官網(wǎng)內(nèi)頁圖2.jpg)
The chamfering of the workpiece machining is even and the milling at its bottom is smooth from viewing of the machining photo. The machining effect gains the good recognize and satisfies to the customers. Roughness at the bottom of the workpiece: Ra 1.1354 umRp 4.1687 umRv 2.6922 umRt 8.1931 umRSm 68.7479 um